User Manual

14
Hob burner injector removal/replacement.
Lift off the appropriate pan rest to release it from the rubber bushes.
Remove the screw in the burner cap and lift off the burner cap and skirt / flame spreader.
With a 7mm A/F socket, unscrew the injector from the bottom of the burner mixing tube.
Replace/refit using the reverse of the above procedure.
Thermocouple removal/replacement
Shut off gas supply and disconnect gas supply pipe from the unit.
Remove the hob from the worktop as above.
From the underside of the hob, disconnect the appropriate thermocouple at the gas valve and at
the shut-off switch attached to the hinge for the glass lid.
Remove the spring clip retaining the thermocouple at the burner.
Remove the thermocouple.
Replace/refit using reverse of the above procedure.
Spark ignition.
Disconnect from gas supply.
Disconnect 12v power wires to spark generator.
Remove appliance from worktop as above.
12v Spark Generator replacement
Located on the underside of appliance.
Remove all electrode wires.
Unscrew and/or unclip the spark generator and lift off the unit.
Replace/refit using reverse procedure.
Spark Ignition Wires.
Pull off the fixing clip on the burner and remove electrode from the burner cup.
Trace the electrode wire back to the generator and pull off the connector.
Replace/refit using reverse procedure.
Glass Lid and Glass Lid Safety Shut-Off Switch.
The glass shut-down lid may be removed with the appliance in-situ. Open the glass lid fully and
use a screwdriver to loosen the clamping screws in the upper leaves of the hinges. The glass
should be carefully lifted from the hinges when the screws are loose enough. Place the glass lid
in a protected area to avoid breakage.
To remove the safety shut-off switch the glass lid must first be removed and the appliance
disconnected from gas and electricity and removed from the cabinet. Disconnect the
thermocouple wires from the switch terminals by pulling straight down, away from the switch
without bending the connecting tabs.
Remove the two hinge-mounting screws from the hinge which carries the shut-off switch and
remove the switch from the hinge. A switch actuating pin is mounted in a hole located on the
underside of the hinge - catch the pin as it will fall out of the hinge as the switch is removed and
retain it for refitting. Refitting is the reverse of removal, including replacing the pin in the hole
underneath the hinge.
.