Owner Manual

Installation /Owner’s Manual 15

Your dealer or an authorized Thetford Service Center must do this

procedure.

Make sure the combustion seal [29] is not broken, is completely

around the refrigerator mounting anges, and is between the

mounting anges and the wall of the enclosure (See Art02454).

If the combustion seal is not complete, exhaust fumes can be

present in the living area of the vehicle. The breathing of exhaust

fumes can cause dizziness, nausea, and in extreme cases, death.

1. Push the refrigerator completely into the enclosure.

2. Put the screws though the upper and lower mounting anges at the front of the

refrigerator.

The rear of the refrigerator has sharp edges and corners. To

prevent cuts or abrasions when working on the refrigerator, be

careful and wear cut resistant gloves.

4. Open the lower intake vent and put the screws through the mounting ange at the rear

of the refrigerator and into the oor.

To avoid possible LP gas leaks, always use two wrenches to loosen and tighten the LP gas supply line at

the refrigerator’s manual shut off valve.

5. Attach the LP gas supply line to the manual shut off valve of the refrigerator.

6. Open the valve at the LP gas tank(s).

Do not allow the leak checking solution to touch the electrical components. Many liquids are electrically

conductive and can cause a shock hazard,electrical shorts, and in some cases re.

7. Examine the LP gas supply line for leaks.

8. Connect the DC wiring to the refrigerator:

- Install the DC fuse or connect the DC wiring to the battery or the converter.

- Connect the DC supply to the refrigerator’s DC wire harness.

9. Connect the AC power cord to the receptacle.

Reinstall the Refrigerator

Replacement Parts

You may purchase replacement parts through your local RV dealer or an authorized Thetford Service Center.

CAUTION

NOTICE

WARNING

Art02454