User Manual

Installation /Owner’s Manual 7

Art02267

- If the depth of the enclosure is more than 660mm, install a wood or an aluminum

or galvanized sheet solid box bafe [21] in the rear of the enclosure (See Art02267

and Art02268).

- Make sure that the bottom of the solid box bafe is 455mm to 470mm above

the bottom of the enclosure [17] (205mm to 220mm above the top of the lower

intake vent opening REF) [18] .

- Make sure that the back of the solid box bafe is perpendicular to the bottom of

the enclosure.

- Make sure that the back of the solid box bafe is either against the top of the

enclosure or against the angled bafe [13] (depending on the vehicle design).

- Make sure that the solid box bafe is 25mm or less [19] from the coils [10]

and condenser [11] of the refrigerator.

- Make sure that the solid box bafe is the full width of the inside of the

enclosure.

- If installing a roof exhaust, it is the responsibility of the OEM / installer to either

ensure the ue enclosure conforms to AS5601 or install an independent ue kit, per

instructions in kit.

- If the design of the vehicle does not allow you to install a roof exhaust vent, install

an upper side-wall exhaust vent.

The refrigerator is 602mm to 610mm max. from the rear of the breaker

to the rear of the condenser [22] and 1196mm to 1204mm max.

from the bottom of the refrigerator to the bottom of the refrigerator

condenser [23] (See Art01601).

Only use an upper side-wall exhaust vent on refrigerator

models that are equipped with a fan. If you use an upper

side-wall exhaust vent on a refrigerator model that is not

equipped with a fan, the refrigerator cooling performance will

be poor.

- Make sure the refrigerator model is equipped with a fan.

Art02268

Art01601

CAUTION

NOTICE