User Manual

Installation / Owner’s Manual 6
10
19
17
Art02264
18
9
19
16
11
13
16
12
15
14
Art02265
14
12
13
16
11
20
19
19
17
18
10
9
16
3. Install the upper exhaust vent:
Make sure that no sawdust, insulation, or other
construction debris is on the refrigerator or in the
enclosure. Debris can cause a combustion hazard and
prevent the refrigerator from operating correctly.
Tighten the screws of the upper roof exhaust cap to 11.5kgf/cm.
Also make sure that the air ow around the upper roof exhaust cap is
not blocked or decreased by other roof mounted features such as a
luggage carrier, an air conditioner, a solar panel, etc.
- If the design of the vehicle allows, install the roof exhaust vent [12] directly
above the condenser [11] of the refrigerator (See Art02264).
- Install a bafe [13] to prevent stagnant hot air in the area [14] above the
refrigerator.
- Make sure there is less than 6mm clearance [15] between the bafe
and the top of the refrigerator.
- Make sure the bafe is the full width of the inside of the enclosure.
- If the design of the vehicle does not allow you to install the roof exhaust vent
directly above the condenser [11] of the refrigerator (See Art02265).
- Align the roof exhaust vent [12] above the condenser [11] of the refrigerator
and move it inboard as necessary.
- Install two bafes [13] to prevent stagnant hot air in the area [14] above the
refrigerator.
- Make sure the bafes are the full width of the inside of the enclosure.
- Make sure that the bafes are no more than 45° from vertical [20].
- Put one bafe between the top rear edge of the refrigerator and the
inside edge of the upper exhaust vent opening.
- Put the other bafe between the outside edge of the upper exhaust
vent opening and the side wall of the vehicle.
- If the depth of the enclosure is less than 635mm, no bafes are necessary at the
rear of the enclosure.
- If the depth of the enclosure is 635mm or more and is less than 660mm, add two
bafes [16] to the rear of the enclosure (See Art02264 and Art02265).
- Put one bafe 455mm to 470mm above the bottom of the enclosure [17]
(205mm to 220mm above the top of the lower intake vent opening REF)
[18].
- Put the other bafe at the lowest edge of the condenser [11] of the
refrigerator.
- Make sure that the bafes are 25mm or less [19] from the coils [10] and
condenser of the refrigerator.
- Make sure that the bafes are the full width of the inside of the
enclosure.
WARNING
!
NOTICE