User Manual

Installation /Owner’s Manual 5

Assemble the Enclosure

1. Make sure the enclosure is: 1415mm high x 600mm wide x 610mm deep.

2. Make sure the oor is solid and level.

- The oor must be metal or a wood panel and extend the full width and depth of the enclosure.

- The oor must be able to support the weight of the refrigerator and its contents.

3. Make sure there are no adjacent heat sources such as a furnace vent, a hot water heater vent, etc.

4. If there is more than 13 mm between either side of the refrigerator and the inside of the enclosure:

- Fill the space with berglass insulation or add a bafe to eliminate the excess clearance.

- Make sure that the rear of the batt-type insulation is between 455 - 485 mm from the face of the enclosure.

- Securely attach the batt-type insulation to the enclosure so that it remains in this position during refrigerator installation, if it

becomes wet, and in windy conditions.

1. Using the following chart, decide which vents and rough opening (RO) sizes to use:

Certied Vent P/N RO Height RO Width

Upper Roof Exhaust Cap 622293 N/A N/A

Upper Roof Exhaust Vent 616319 610mm 133mm

Upper Exhaust and 631140 249mm 490mm

lower Intake Side Vent

Upper Side Exhaust Vent 631247 156mm 450mm

Flue Extension kit 637085 N/A N/A

(Use with 631247 exhaust vent)

Independent Flue Kit 636974 N/A N/A

(use with 631140 exhaust vent or with roof exhaust)

2. Install the lower intake vent (See Art02264, Art02265, and Art02266):

The lower intake vent is also the service access opening for the components

on the rear of the refrigerator.

Make sure the bottom of the opening of the lower intake vent is

even with or immediately below the oor level. This allows any

leaking LP gas to escape to the outside and not to collect at oor

level.

- Make sure the bottom of the opening of the lower intake vent [9] is even with or immediately below the oor level.

- Align the right edge of the lower intake vent with the right edge of the refrigerator cabinet as viewed from the rear.

Install the Lower and Upper Vents

Art02266

WARNING

NOTICE