Manual

Installation Manual 7
- If the construction of the vehicle does not allow the distance [25] to be
940mm for N314E.3F models, the distance can be as little as 739mm (see
Art02422) if you:
- Add two bafes [17] to the rear of the enclosure:
- Make sure the distance [290] from the bottom of the enclosure to
the top of the lower bafe is between 254 and 267mm.
- Put the upper bafe at the lower edge of the condenser of the
refrigerator
- Make sure the upper bafe is between zero (0) and 6mm [15]
below and zero (0) and 6mm away from the condenser of the
refrigerator.
- Make sure the bafes are the full width of the inside of the
enclosure.
- Install 636221 and 622782 as shown for the ue exhaust. 622782
may be cut off to t over 636221.(See Art02610)
Art02422
13
17
25
14
17
15
290
191
11
Install the Refrigerator
Put the refrigerator into position (see Art01288):
Make sure the combustion seal [28] is not broken, is
completely around the refrigerator mounting anges [156],
and is between the mounting anges and the wall of the
enclosure. If the combustion seal is not complete, exhaust
fumes can be present in the living area of the vehicle. The
breathing of exhaust fumes can cause dizziness, nausea, or
in extreme cases, death.
- On N414E.3F and N514E.3F models, remove the door from the refrigerator (See
“Reverse the door swing” section).
- Put screws through the holes of the refrigerator mounting anges and into the
enclosure wall.
To avoid bending the breaker, make sure that the screws are
perpendicular to the breaker and do not overtighten the screws.
- Attach the door to the refrigerator.
- Put a screw through the holes [121] in the braces at the lower rear corners of the
refrigerator and into the oor.
Art01288
28
156
121
WARNING
!
NOTICE
Installation Options
Install the decorative door panel:
The decorative panels must be 5 mm or less in thickness.
- Make a decorative door panel [38] that is (See Art00977):
- 659 mm high x 511 mm wide for N314E.3F models.
- 787 mm high x 541 mm wide for N414E.3F models.
- 939 mm high x 541 mm wide for N514E.3F models.
- Push the decorative door panel into the slots [157] of the door end caps
[158].
- Push each panel retainer [37] into the slot on the edge of the door.
NOTICE
Art00977
38
158
37
157