Product Manual

Owner’s Manual 7
- Touch the CABINET COMPARTMENT [6] button to set the fresh food compartment temperature setting.
-Using the + [4] or – [2] buttons adjust the temperature setting.
- The mode [3] will display the temperature setting
- 0 is off
- 1 is the warmest setting
- 5 is the coldest setting
- Press any button to return the control to activate mode, the mode [3] will illuminate. The display will return to standby mode after 5
seconds.
- Touch the NIGHT MODE [7] button to set the refrigerator to night mode. The blue indicator will illuminate.
- Night mode will turn off automatically after eight hours or if you push the night mode button again to turn the blue indicator light off.
- This 8 hour night mode setting can be changed by pressing the night mode button for 3 seconds. After the 3 seconds, the default 8
hours will be shown in the display . To change this setting, press the “+” or “-”, then press night mode button to make the setting go into
effect.
- The new setting is archived in the memory until it is changed.
Shut down:
- To shut down the refrigerator, touch and hold the ON/OFF button [1] for 5 seconds and release.
- Once the refrigerator is turned OFF there is a 5 minute wait cycle before the refrigerator can be turned ON. The refrigerator will not
turn on again until the 5 minute wait is up.
Do not operate the refrigerator when the ambient temperature is above 43° C. Operation above
recommended ambient temperatures can cause permanent damage to the compressor. Operation when
the ambient temperature is higher than 43° C. can result in poor cooling performance.
DC Operation Guidelines:
Y
our refrigerator will give you years of trouble free service if you do these simple checks every three to six months:
- Keep the fresh food and frozen food compartment clean. See “Cleaning”.
- Defrost the refrigerator as necessary. See “Defrosting”.
- Make sure the door seals correctly. See “Door Sealing“.
- Be aware of any cooling changes that are not because of weather, loading, or thermostat changes. If changes occur, contact your
dealer or an authorized Thetford Service Center.
- Make sure the air flow in the lower intake vent, through the refrigerator condenser and coils and out the upper exhaust vent is not
blocked or decreased.
CAUTION
!
Refer to the Installation Manual for DC Operation requirements and guidelines.
Refrigerator Care Checklist