Installation Manual For Australian refrigerator models: T1274 Part No.
Table of Contents Safety Awareness .....................................................................................................................................................................................2 Safety Instructions ....................................................................................................................................................................................2 Assemble the Enclosure .....................................................................
Assemble the Enclosure Make sure that the enclosure is the correct size: - For T1274 models – 1521-1524 mm high x 597-600 mm wide x 610 mm deep. - For enclosures deeper than 610 mm ensure that the refrigerator is inserted into the enclosure only to the depth of the breaker (2). This ensures that the door latches can be assessed, and the doors can be opened to the maximum extent without interference from the sides of the enclosure.
Key Refrigerator Dimensions These key refrigerator dimensions are for your reference as necessary (See Art02741). Refrigerator cabinet width: 592 mm................................... 1 3 Refrigerator cabinet height: 1521 mm................................. 2 Refrigerator top to control top: 53 mm..................................... 3 4 1 Enclosure depth: 610 mm................................... 4 Refrigerator bottom feet to middle handles: 1034 mm..................................
Installation Options Reverse the door swing This refrigerator has door hinges that allow you to change the direction that the door opens by moving the hinges to the opposite corner. 371 1. Remove the refrigerator from the enclosure, to allow access to the bottom hinges. 2. Remove the frozen food and fresh food door (See Art02737): - Open the frozen food door. 41 - Remove the screws from the centre hinge pin. [71] 65 - Pull the doors away from the cabinet and lift the door off the centre hinge.
Install the Refrigerator 1. Fasten the refrigerator into the enclosure. (See Art 02736): - Push the refrigerator fully into the enclosure opening. - Install shims between enclosure wall and refrigerator to prevent excessive bowing of refrigerator cabinet walls when installing mounting screws. - Install 6 provided mounting screws, 3 on each side. - Install hole plugs to cover screw holes.
Connect the Electrical Components Electrical current necessary: DC Operation T1274 models - 12 volts DC voltage (10.4 volts min. - 15.4 volts max.) Make no changes to any of the electrical wiring supplied with the refrigerator. Any changes that you would make to the electrical wiring will void the warranty. Connect the 12V DC supply: To reduce the risk of electrical interference from other DC appliances and induction from voltage spikes: - The refrigerator must have an independent filtered 12V DC supply.
Connect the Electrical Components 1. Select Wire Size: ! WARNING Assuming a minimum voltage of 12V is supplied by the vehicle battery, AWG wire size should be selected so that the voltage drop from the vehicle battery or power converter is no more than 0.3V. - Recommend Wire Size : - If the distance is 0 - 3 m, use 6mm2 min. wire size. - If the distance is 3-6 m, use 8mm2 min. wire size. - If the distance is over 6 m, use 10mm2 min. wire size.
Connect the Electrical Components Controls: -Touch and release the ON/OFF [1] button to turn the refrigerator on.(ART02735) - If the indicator light, below the button, glows solid blue, it means the refrigerator is operating correctly. NOTICE The frozen food compartment and cabinet work independent of each other and both must be adjusted to their desired temperature setting. - Touch the FROZEN FOOD COMPARTMENT [5] button to set the compartment temperature setting.
