Instruction Manual
Table Of Contents
- Click on + to expand or - to hide each section.
- Table of Contents
- Safety Awareness
- Safety Instructions
- Certification and Code Requirements
- Ventilation Requirements
- Key Refrigerator Dimensions
- Assemble the Enclosure for the Refrigerator
- Install the Lower Intake Vent
- Optional Installation
- Install an Upper Roof Exhaust Vent
- Install the Baffles for an Upper Roof Exhaust Vent
- Install an Upper Side-wall Exhaust Vent
- Install the Baffles for an Upper Side-wall Exhaust Vent
- Install an Air Deflector (optional)
- Install Decorative Door Panels (non-metal door models)
- Install the Refrigerator
- Connect the Electrical Components
- Connect the Propane Gas Components
- Connect the Ice Maker (optional)
- Ignition and Start Up
Installation Manual 21
- If a less efficient energy source is not available:
- An audible alarm starts.
- A fault code shows in the center display.
- Refer to the “Fault Codes” section of this manual.
Set the controls to manual mode operation:
- Push the ON / OFF button to turn the refrigerator on.
- Push and hold the MODE button until the letters “ AC” show in the center display and then release.
- After ten seconds, the “AC” goes off and only a green power ON light remains.
- Push and hold the MODE button until the letters “LP” show in the center display and then release.
- After ten seconds, the “LP” goes off and only a green power ON light remain
Do a test of the gas safety valve:
1. Start up the refrigerator in the manual mode operation.
2. Open the lower intake vent.
3. Remove one wire from the solenoid of the gas safety valve at the rear of the refrigerator.
4. Within 30 seconds, the flame should extinguish. This means that the gas safety valve is operating correctly.
5. Put the wire back on the solenoid of the gas safety valve.
6. Close the lower intake vent.
Shut down - all models:
To shut down the refrigerator, push and hold the ON/OFF button for one second.