Instruction Manual

Table Of Contents

Installation Manual 19

Connect the Ice Maker (optional)

The ice maker is assembled to the refrigerators at the factory as optional equipment. If the refrigerator does not have a factory

installed ice maker, one can not be added to the refrigerator at a later time.

The refrigerator installer must connect a cold water supply line to the solenoid valve at the rear of the refrigerator. The following are

necessary to connect the icemaker:

- 1/4 in. OD copper tubing for the water supply line.

- 1/4 in. OD plastic tubing for the water supply line.

- 1/4 in. shut off valve in the water supply line. This should be easily accessible through the lower intake vent.

Connect the water supply line:

Install a 1/4 in. OD water supply line [43] from the

water shut off valve of the vehicle to the solenoid

water valve [44] at the rear of the refrigerator (See

Art01014):

NOTE: A brass compression nut [45], a brass

sleeve, a plastic sleeve [46] , and a brass

insert [47] are supplied and attached to

the rear of the refrigerator (See Art01604).

- Put the compression nut and then the sleeve

onto the water supply line [43].

- For copper tubing, use the brass sleeve.

- For plastic tubing, use the plastic sleeve

[46].

- For plastic tubing with .040 in. wall

thickness, also use the brass insert [47].

- Flush the water supply line until the

water is clear.

- Put the tubing into the adapter [48] until it is against the stop of the adapter.

- Tighten the compression nut by hand (hard finger tight).

- Using two wrenches, tighten the compression nut 1 ½ to 2 turns.

- Open the water shut off valve of the vehicle.

- Examine the connections for leaks.

Art01014

Art01604