User Manual
Table Of Contents
- Click on + to expand or - to hide each section.
- Table of Contents
- Safety Awareness
- Safety Instructions
- Certification and Code Requirements
- Ventilation Requirements
- Key Refrigerator Dimensions
- Assemble the Enclosure for the Refrigerator
- Install the Lower Intake Vent
- Optional Installation
- Install an Upper Roof Exhaust Vent
- Install the Baffles for an Upper Roof Exhaust Vent
- Install an Upper Side-wall Exhaut Vent
- Install an Air Deflector (optional)
- Install Decorative Door Panels (non-metal doors)
- Install the Refrigerator
- Connect the Electrical Components
- Connect the Ice Maker (optional)
- Start Up
- Fault Codes
Installation Manual 7
You can change enclosures that were made for Norcold model N8XX refrigerators so that you can put Norcold model 121X refrigera-
tors into them.
To change the Norcold model N8XX refrigerator enclosure [130] into the Norcold model 121X refrigerator enclosure [131] (See
Art01597):
- Increase the height of the enclosure by 3 3/8 inches [132].
- Increase the width of the enclosure by 8 13/16 inches [133].
- Make sure to add the additional width to the left side of the enclosure (as looking at the rear of the refrigerator).
Install the necessary baffles only as written in the “Install the Upper and Lower Vents” section of this manual.
The locations of the 12 VDC supply, the 120 VAC supply, and the propane gas supply line do not change.
Optional Installation
12
Art01597
12
11
9
130
131
132
N8XX
120X
133