Configuration Guide User Manual

2. Network Settings
Here you must make a decision based on how you
intend to use the unit. If you are not going to access
the device’s built-in Web Server, then set the DHCP
field to ON and the settings boxes for IP address, etc.
will disappear and can be ignored. If you are going
to use the internal Web Server, however, this
requires a fixed IP address. In this case set DHCP to
off and make the entries for the IP Address you will
use along with the Subnet Mask, Default Gateway,
and DNS Server(s). If you are unsure what to enter
for these values see Appendix I; Determining Router
& Server IP Addresses
Note that when you select an entry in the right hand
window you will also see some basic guidance for it
along the bottom.
If you have a TR-700AW you will also need to make
the settings for your wireless LAN. If you are in
doubt about what settings to use here check the
documentation that came with your router, or with
your IT department. Remember that the SSID and
password are case sensitive. As a note, the TR-
700AW supports WPA2 encryption for use in
802.11n networks.
Note: At this time the TR-700AW does not support
Enterprise Mode encryption.