Configuration Guide User Manual

You can now perform the Transmission Tests. Note that while the test is in progress you will usually see a status in the Result
window. If the test completes without error you will see a Successful result. If not, a Failure will be reported along with some
information about the cause. This usually requires changes to the settings that were made earlier.
NOTE: Most E-Mail failures are the result of authentication issues. If you receive a Failure result for an attempted E-Mail see the
comments relating to this in Section 5: Warning Settings.
Once all of the Transmission Tests for the operations you have enabled have been completed you can close the TR-700W for
Windows software and the logger is ready to deploy.