Manual

Quick Start Guide for ThermaData Loggers
• Checkforversionupdatesatwww.thermoworks.com/software
• RemoveoldversionsofThermaDataLoggersoftwarepriortoinstallingnewversion(yourdatafiles
willnotberemovedorlost)
• Installthesoftwarebyfollowingon-screeninstructionsBEFOREplugginginterfaceorcradleintoPC
• OpentheThermaDataprogramusingthedesktopicon
Using the ThermaData Logger
Setting up the logger
• ConnecttheloggertothePCusingthe‘Serial’or‘USB’interfacelead(ThermaDataSeriesl)orUSB
cradle(ThermaDataSeriesII)
• Select‘LoggerSettings’fromthedrop-down‘Logger’menu
• SelectComPort,eitherThermaDataloggercradleorSiliconLabs
• EnteranamefortheloggerintheTitle(UserID)boxifrequired
• Selecttemperaturesettingsfor‘over’or‘under’alarmusingthedrop-downmenuboxes
• Selectthedatastoragemethod—‘Stopwhenfull’or‘Overwriteoldestdata’
• Selecta‘StartDelay’(note:forimmediatestartenter0hours,0minutes)
• Selectthelogginginterval(note:thetotaltimethelogwilllastisshownbelowthedrop-downbox)
• Clickthe‘SendSettings’button
• Starttheloggerbyclickingthe‘Startbutton’onthePCscreenorbypressingthebuttononthelogger
(ThermaDataSeriesl)orusingthemagnetkeyfob(ThermaDataSerieslI)untiltheLEDsflash
Retrieving data from the logger
• ConnecttheloggertothePCusingthe‘Serial’or‘USB’interfacelead(ThermaDataSeriesI)orUSB
cradle(ThermaDataSeriesII)
• Select‘GetData’fromthedrop-down‘Logger’menu
• ‘View’readingsusingdatawindoworgraphwindow
(Full operating instructions for ThermaData Loggers are found in the ‘Help’ tab within the software.)