Installation Guide

THERMOFILM® – The complete underfloor heating solution for all wood & laminate floors.
Thermosoft International Corporation Installation Manual: ThermoFilm®
Page 12
Using a sharp knife, cut a channel in the
underlayment or insulation along the connection
lead/thermostat wall side to accommodate the
connection leads (fig.6). Run the leads in the
channel to the junction box and tape over using
duct tape. The leads must never be in contact
with the THERMOFILM heating elements.
WARNING: Risk of electric shock and fire.
Damage to supply conductor insulation may
occur if conductors are routed less than 2” from
this heating product. Refer to above for
recommended means of routing supply
conductors.