Installation Guide

Rev.1.12.09.10 2
Cautions:
THIS EQUIPMENT SHALL BE INSTALLED ONLY BY QUALIFIED PERSONNEL WHO ARE FAMILIAR WITH
THE CONSTRUCTION AND OPERATION OF THE APPARATUS AND THE RISKS INVOLVED.
THE INSTALLATION OF THIS HEATING PRODUCT SHALL BE IN ACCORDANCE WITH THE
MANUFACTURER’S INSTRUCTIONS AND LOCAL AND NATIONAL CODES.
IN CANADA, THE INSTALLATION SHALL BE MADE ACCORDING TO THE PROVISIONS OF SECTION 62 OF
THE CANADIAN ELECTRICAL CODE, PART 1.
WARNING - AS DESCRIBED IN THESE INSTRUCTIONS, LEAD WIRES ARE NOT TO BE ROUTED OVER
PADS OR COME INTO CONTACT WITH THE HEATING ELEMENTS AS DAMAGE TO SUPPLY CONDUCTOR
INSULATION MAY OCCUR IF CONDUCTORS ARE ROUTED TO CONTACT HEATING ELEMENTS. REFER
TO INSTALLATION INSTRUCTIONS FOR RECOMMENDED MEANS OF ROUTING SUPPLY CONDUCTORS.
THE TYPE AND THICKNESS OF FLOOR COVERING MATERIALS USED WITH THIS PRODUCT MUST NOT
EXCEED A THERMAL INSULATION “R” VALUE OF 2.0.
CAUTION: USE COPPER ONLY AS SUPPLY CONDUCTORS.
THERE ARE NO SPECIAL CRIMPING TOOLS REQUIRED FOR THIS PRODUCT.
ATTENTION: CONIFIER L’INSTALLATION DE CE MATERIEL AUN PERSONNEL QUALIFIE, QUI CONNAIT
BIEN L’APPAREIL ET LES RISQUES INHERENTS.
CE SYSTEME DE PANNEAUX CHAUFFANTE DOIT ETRE INSTALLECONFORMEMENT AUX EXIGENCES DE
TOUS LES POUVOIRS DE REGLEMENTATION.
ATTENTION: UTILISER DES CONDUCTEURS EN CUIVRE SEULEMENT.
OVERVIEW:
WarmFlex™ may be used in three types of flooring applications:
1. Floating laminate and floating wood floors.*
2. Glued-down engineered and solid wood floors.
3. Ceramic tile, marble, porcelain, slate, stone and other cementitious floor coverings.
4. Carpet and vinyl floors after first covering WarmFlex with self-leveling cement.
• Do not install WarmFlex in walls.
• For Installations not covered in these directions, consult customer service before installation.
• Installations not performed within the stated manner may void all warranties.
Refer to Floor Covering Manufacturer’s specifications for compatibility of their product over radiant heat
before installation.
Each of the above applications requires 5 basic steps:
A. Electrical Rough-In
B. Planning & Preparation
C. WarmFlex Installation
D. Floor Covering Installation
E. Final Wiring & Connection