Owner's manual

CONTRACTOR
Page 1
1. Warnings and Disclaimer – Installation Precautions
Please read and understand the warnings and instructions fully before you begin this installation and keep
them handy for future reference.
The manufacturer will assume no responsibility and the warranty will be void if the installer or the user does not
adhere to the following precautions :
1.1 This humidi er will be connected to and used under water pressure and it must be installed in such a
way that if a leak occurs, the water could not cause any damage to the property. Make sure all water
connections are properly installed or a water leak could occur.
1.3 Do not install a humidi er where the surrounding temperature may be 32ºF (0ºC) or colder. Freezing
water will damage the humidi er and burst the supply pipe, resulting in home damage.
1.6 Do not install a humidi er if the city water pressure exceeds 90 psi. Check the local codes related to
pressure reduction.
1.8 The installation, wiring and plumbing of the humidi er must comply with national and local electrical,
plumbing and building codes.
1.9 Electrical wiring and water tubes must not come in contact with sharp edges or hot surfaces.
1.10 Make certain an appropriate drain system is installed and there is no resistance to the ow of the
discharged water.
1.11 Do not set the humidity level higher than that recommended or condensation damage will occur.
1.13 Always shut the power off before you start the installation or when doing maintenance. An electric
shock from 120 or 240 volts could cause serious injury.
1.14 When you perform maintenance, please be careful because the unit can be extremely hot. Always
allow enough time for the unit to cool down.
1.15 To prevent electric shock or injuries, never operate the humidi er without the cover as there are high
voltage and hot components inside.
1.16 This humidi er will only work with non demineralized water. The maximum water supply temperature is
86 ºF (30 ºC)
HOME OWNERHOME OWNER