Installation Manual

Accu-Wave Chapter 2 Hardware Installation
TN Technologies 2-1
Chapter 2 Hardware Installation
Licensing
All microwave frequency tuning is completed at the factory (TN Technologies Inc.,
Round Rock, Texas).
United States
For installations on metal tanks, the Accu-Wave complies with FCC Part 15
requirements, FCC ID MCO1440-15, and no additional licensing is required (Part 15
certification is pending)
Note:
Operation under Part 15 of the FCC Rules is subject to the two following
conditions: (1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that
may cause undesired operation.
For installations other than on metal tanks, you must obtain and display a FCC Part 90
license at the installation site, FCC ID MCO1440 (Part 90 certification is pending). TN
Technologies can assist you with licensing. For assistance, call or fax one of the
following numbers:
• Phone: [phone] (US only)
• Main Office: [phone]
• FAX: [phone]
Canada
(i) This device shall be installed and operated in a completely enclosed metal
container to prevent RF emission which otherwise can interfere with
aeronautical navigation. Installation shall be done by trained installers, in
strict compliance with the manufacturer’s instructions.
(ii) The user of this device is on a “no-protection non-interference” basis. That
is, the user shall accept Government and NAV CANADA operations of high
powered radar in the same frequency band which may interfere with this
device. Devices found to interfere with Government and NAV CANADA
operations will be required to be removed.
(iii) The user is required to notify the TN Technologies at 2555 N. IH 35, Round
Rock, TX, 78680 of the postal address of the user, the address where the
device is installed, the device model number, and the date of installation.