Cov lus qhia

Table Of Contents

How to change alarm setpoints on TSX High Performance Refrigerators and Freezers.

Follow Steps below:

1. Turn the key to the power on position.

2. Enter the programming mode by pressing the Scan button and holding for 5 seconds. The display

will then flash “Prg” to indicate that you have entered the programming mode (see table below).

3. Release Scan button. The first number is the control setpoint.

4. Press scan button once to move through menu. The next setting is cold alarm setpoint. Adjust up

and down arrow to change.

5. Press scan button again to move on to warm alarm setpoint. Use up and down arrow to adjust.

6. Push scan button one more time to exit program menu.

Note: If keypad is untouched for 30 seconds while in program (PRG) mode, the PRG mode shall be exited.

PAGE 1
How to change alarm setpoints on TSX High Performance Refrigerators and Freezers. Follow Steps below: 1. Turn the key to the power on position. 2. Enter the programming mode by pressing the Scan button and holding for 5 seconds. The display will then flash “Prg” to indicate that you have entered the programming mode (see table below). 3. Release Scan button. The first number is the control setpoint. 4. Press scan button once to move through menu. The next setting is cold alarm setpoint.
PAGE 2
Page 2 of 2 Title: Instructions: TSX High Performance Refrigerators and Freezers - How to Change Alarm Setpoints Audience: Public Author: Alex Franklin