Instruction Manual
Installation and Operation Handbook Programmer Operation
2408 and 2404 Controller 5-15
Event output 1
(16-segment programmers only)
Appears in all segments, except ‘cALL’ segments.
Use
or to set output 1:
• OFF: Off in the current segment
• on: On the current segment.
Press
Further event outputs
(16-segment programmers only)
Up to eight (8) event outputs may appear in this list where ‘n’ =
event number.
Pressing
will step through all the remaining event outputs.
Note:
If you are not using all of the event outputs, you can step
immediately to the next segment number by pressing .
Press
Synchronisation event output (only appears if configured)
Use
or to select:
• YES: Synchronisation Enabled
• no: Synchronisation Disabled
Note:
This event output, if used, occupies the position of ‘out8’.
Press
End segment
Use
or to select:
• dwEl: An indefinite dwell
• rSEt: Reset.
• S OP: End Segment Output Power Level
Press
SYnc
YES