Instruction Manual

Programmer Operation Installation and Operation Handbook
5-14 2408 and 2404 Controller
Ramp rate
Ramp rate for rmP.r segments
Using
or , set a value for the ramp rate, ranging from 0.0 to
999.9. The units are the ramp units (rmP.U) set earlier in this
sequence.
Press
Duration time
Time for a dwEl segment, or time to target for a rmP.t
segment.
Set the time using
or . You have set the units earlier in
this sequence. [dwL.U defines the units for dwEl segments:
rmP.U defines the units for rmP.t segments.]
Press
Called program number
Only appears for cALL segments.
(multi-program controllers only)
Set a called program number from 1 to 4, or from 1 to 20, using
or .
Press
Number of cycles of the cALLed program
Only appears for cALL segments.
(multi-program controllers only)
Sets the number of cycles of the cALLed program from 1 to 999,
using
or .
Press
Continued on the next page.