Instruction Manual
Programmer Operation Installation and Operation Handbook
5-10 2408 and 2404 Controller
CONFIGURING DIGITAL INPUTS TO SELECT PROGRAM NUMBER
The program number can be selected by external BCD inputs from, for example, a
thumbwheel switch.
The appropriate number of digital inputs must be installed in the controller and be configured
for this function - see Chapter 6, Configuration.
To invoke this mode of operation, the parameter ‘bcd’ in ‘inst-Conf’ must be set to
‘PrOg’.
bcd
PrOG
Press until you reach ‘bcd’.
Use the
or buttons, to select ‘PrOG’.