Instruction Manual
Installation and Operation Handbook Programmer Operation
2408 and 2404 Controller 5-9
Power fail strategy
Use
or to select
•
cont: Continue from last setpoint
• rmP.b: Ramp from PV to setpoint at last ramp rate
• rSEt: Reset the program.
Press
Servo type
Use
or to select:
• to.PV: Servo to PV
• to.SP: Servo to SP
Press
Event Outputs (not in 8-segment programmer)
Use
or to select:
• no: Event outputs disabled
• YES: Event outputs enabled
Press
Synchronisation (not in 8-segment programmer)
Use
or to select:
• no: Synchronisation disabled
• YES: Synchronisation enabled
Press
to return the list header.