Instruction Manual

Operation Installation and Operation Handbook
2408 and 2404 Controller 2-13
Name Description
ProG
Program edit list − Present only in setpoint programming controller.
For a fuller explanation of these parameters refer to Chapter 5
PrG.n Select program number (Only on 4, or 20, program versions)
Hb Holdback type for the program as a whole (if configured)(OFF, Lo, Hi, or bAnd)
Hb V
Holdback value (in display units)
rmP.U Ramp units (SEc, min, or Hour) [for both rmP.r and rmP.t type segments]
dwL.U Dwell units (SEc, min, or Hour)
CYC.n Number of program cycles (1 to 999, or ‘cont’)
SEG.n
Segment number
tYPE
Segment type:
(End) (rmP.r=ramp rate) (rmP.t=ramp time) (dwel) (StEP) (cALL)
The following parameters depend on the tYPE selected, as shown below.
End rmP.r rmP.t dwEl StEP cALL
Hb Holdback type: OFF, Lo, Hi, or bAnd
tGt
  
Target setpoint for a ‘rmP’ or ‘StEP’ segment
rAtE

Ramp rate for a ‘rmP.r’ segment
dur
 
‘dwEl’ time / Time to target for a ‘rmP.t’ segment
PrG.n

cALLed ProGram number
cYc.n

No. of cycles of cALLed program
outn
    
Event output: OFF/on (not 8-segment programmer)
SYnc
   
Segment synchronisation: no/YES
(not 8-seg progr)
End.t

End of prog − dwEl, RSEt, S OP