Instruction Manual
Operation Installation and Operation Handbook
2-12 2408 and 2404 Controller
PARAMETER TABLES
Name Description
Home list
Home Measured value and Setpoint
OP
% Output level
SP
Target setpoint (if in Manual mode )
m-A
Auto-man select
AmPS
Heater current (With PDSIO mode 2)
C.id
Customer defined identification number
+ Extra parameters, if the ‘Promote’ feature has been used (see Chapter 3, Edit Level).
run
Program run list − Present only in setpoint programming controllers
PrG Active program number (Only on 4, or 20, program versions)
StAt Program status (OFF, run, hoLd, HbAc, End)
PSP
Programmer setpoint
CYC
Number of cycles remaining in the program
SEG
Active segment number
StyP
Active segment type
SEG.t
Segment time remaining in the segment units
tGt
Target setpoint
rAtE
Ramp rate (if a rate segment)
PrG.t
Program time remaining in hours
FASt Fast run through program (no / YES)
out.n Event output states (OFF / on) (not 8-segment programmer)
SYnc Segment synchronisation (no / YES) (not 8-segment programmer)
SEG.d Flash active segment type in the lower readout of the home display (no / YES)