Instruction Manual
Installation and Operation Handbook Configuration
2416 Controller 6-11
Name Description Values Meaning
For ‘id’ = ‘cms’ use this parameter table:
Func
Function
mod
Modbus protocol
EI.bi
Eurotherm Bisynch protocol
bAud
Baud Rate
1200, 2400, 4800, 9600, 19.20(19,200)
dELy no
No delay
Delay - quiet period, required
by some comms adaptors
YES
Delay active - 10mS
The following parameters only appear if the function chosen is Modbus protocol.
Prty
Comms Parity
nonE
No parity
EvEn
Even parity
Odd
Odd parity
rES
Comms Resolution
FuLL
Full resolution
Int
Integer resolution
dELy no
No delay
Delay - quiet period, required
by some comms adaptors
YES
Delay active - 10mS
For ‘id’ = ‘pds’ use this parameter table:
Func
Function
nonE
No PDSIO function
SP.oP
PDSIO setpoint retransmission
PV.oP
PDSIO PV retransmission
Er.OP
PDSIO error signal retransmission
OP.oP
PDSIO output power retransmission
VAL.L
Retransmitted Value Low
VAL.H
Retransmitted Value High
For ‘id’ = ‘Pdsi’ use this parameter table:
Func
Function
SP.iP
PDSIO setpoint input
VAL.L
Setpoint Displayed Value - Low
VAL.H
Setpoint Displayed Value - High
VAL.L
100%0%
VAL.H
Displayed Value
Retransmitted
Output
VAL.L
100%0%
VAL.H
Displayed Value
Electrical Input