Instruction Manual

Configuration Installation and Operation Handbook

6-2 2416 Controller

6.1 SELECTING CONFIGURATION LEVEL

There are two alternative methods of selecting Configuration level:

• If you have already powered up, then follow the access instructions given in Chapter 3,

Access levels.

• Alternatively, press

and together when powering up the controller. This will

take you directly to the ‘ConF’ password display.

6.1.1 Password entry

When the ‘ConF’ display appears, you must enter the

Configuration password (which is a number) in order to

gain access to Configuration level.

Enter the password using the

or buttons.

The configuration password is set to ‘2’ when the

controller is shipped from the factory.

Once the correct password has been entered, there is a two

second delay, after which the lower readout will change to

‘PASS’ indicating that access is now unlocked.

Note: A special case exists if the password has been set to

‘0’. In this situation, access is permanently unlocked and

the lower readout will always show ‘PASS’.

Press to enter configuration.

(If an incorrect password has been entered and the

controller is still ‘locked’ then pressing

at this point

will take you to the ‘Exit’ display with ‘no’ in the lower

readout. Simply press to return to the ‘ConF’

display.)

You will obtain the first display of configuration.

Conf

pass

inst

Conf