Instruction Manual

Installation and Operation Handbook Programmer Operation

2416 Controller 5-13

Ramp rate

Ramp rate for ‘rAtE’ segments.

Using

or , set a value for the ramp rate, ranging from 0.00

to 999.9 (the units will be the ramp units (‘rmP.U’) set earlier in

this sequence).

Press

Duration time

Time for a ‘dwEl’ segment, or time to target for a ‘rmP.t’

segment.

Set the time using

or . You have set the units earlier in this

sequence.

Press

Called program number

Only appears for ‘cALL’ segments.

(4-program controllers only)

Set a called program number from 1 to 4, using or .

Press

Number of cycles of the called program

Only appears for ‘cALL’ segments. (4-program controllers only)

Set the number of cycles of the cALLed program from 1 to 999,

using

or .

Press

Continued on the next page.

rate

1.0

dur

1.0

Prg.n

cyc.n