Instruction Manual

Installation and Operation Handbook Programmer Operation

2416 Controller 5-9

Power fail strategy

Use

or to select:

• cont: Continue from last setpoint

• rmP.b: Ramp from PV to setpoint at last ramp rate

• rSEt: Reset the program

Press

Servo type

Use

or to select:

• to.PV Servo to PV

• to.SP Servo to SP

Press

Event Outputs (not in 8-segment programmer)

Use

or to select:

• no: Event outputs disabled

• YES: Event outputs enabled

Note: The term Sync appears on 2416 but is not operational

and should be set to no. It appears in order to maintain software

consistency with 2408 and 2404 controllers.

Press

to return to the list header

Pwr.f

cont

srvo

to.pV

out

sync