Instruction Manual

Configuration Installation and Operation Handbook

6-16 2408 and 2404 Controller

Name Description Values Meaning

For ‘id’ = ‘Pdsi’ (PDS setpoint input) use this parameter table:

Func

Function

SP.iP

PDS setpoint input

VAL.L

Setpoint Displayed Value - Low

VAL.H

Setpoint Displayed Value - High

Note: Having configured the module function as remote setpoint you must then specify the type of

remote setpoint in the SP-conf list

Comms 2 module config

Same as HA but is only available as PDS.

VAL.L

100% 0%

VAL.H

Displayed Value

Electrical Input