Installation Guide

Doc No. 81159 Page 3 of 17 Rev D 1/17 JWJ
START HERE
This Unit is a Commercial Unit
It Must Be Installed By a Licensed Electrician and Plumber
In order to properly install this system for the first time you must have the following:
Quantity = 1, SD Series Superduty Steam Generator, per steamroom
Quantity = 1, SDK Accessory Kit, per steamroom
Included in the two kits:
 Installation Instructions
 Superduty Steam generator
 Master Controller
 Steam room sensor w/ 50 foot lead wire.
 Polished chrome steam head
 30 Minute Mechanical Timer w/bezel
 NEMA rated wall power receptacle (240v or 480v)
 100 foot data cable
 20”x 3/8 comp hose
and 1/2” NPT adapter
 Hardware packet
Materials Needed:
 1/2” Brass ball valve for water supply
 Proper electrical supply
 Pipe compound
 Copper or brass nipples
(Size and quantities per Instructions)
 In-line filter (recommended)
 1” brass or copper union
(Service disconnect)
 1” x 6” NPT copper pipe nipple
 3/4” brass or copper union
 3/4” x 6” NPT pipe nipple
(service disconnect)
 Wire (sizes and quantities per
Instructions)
 Copper tubing or pipe
 Wire cap nuts
 Flex conduit
 Brass or copper tee fitting and plug
Tools Needed:
 Pipe wrench
 Tubing cutter
 Flaring tool (if flared fittings are used)
 Pipe thread cap
 Wire cutters and wire strippers
 Adjustable wrench
 Screwdrivers (philips and slotted)
 Solder & flux
 3/16” & 1-1/2” masonry drill bits
 Drill motor
 Propane torch
 Other tools as may be required
Generator size 18Wx21Dx48H