Installation Guide

Doc No. 81159 Page 11 of 17 Rev D 1/17 JWJ
Do Not Mount inside the Steamroom
1. The Master Controller should only be accessible to authorized personnel and can be
mounted in an office area, by the actual steam generator, at the front desk or where
ever is convieniant and secure for the club or spa.
2. This device is designed for use with a 2 gang standard recepticale box.
3. Install the recepticale box keeping in mind that 3 other devices will be converging at
this point.
A. Outside room Timer
B. Generator control data cable
C. In Steamroom Tempature sensor
4. After A-B-C have been ran through the wall box, place back plate over the wall box
and attach with the supplied screws. Make all connections to controller then attach
the controller to the backplate with the supplied #8-32 screws.
Failure to follow installation instructions specifically may cause the warranty to be void!
From: In-room
Temp Sensor
From: Outside
Room Timer
From: Generator