Installation Guide

Read warnings on page 2. For illustrative purposes only. Consult with qualified professional for steam room construction details.
7
THERMASOL.COM
I
800.776.0711
Steamhead Location
Upon final installation mount steamhead
with facing up to allow aromatherapy
well to dispense steam.
DO NOT install the steamhead near the seating area or
the user.
DO NOT forget to install the steamhead rough-in fitting!
Install the steamhead 12" from the floor or
bathtub rim and 6" from any corner.
Steamhead is to be mounted as far as possible
from typical bathing position (seated or standing)
and installed as far from the in-shower controller as
possible.
i. For retrofit to existing finish wall:
Drill a 2-1/2" diameter hole in the shower wall or
wall above bathtub rim for the steam outlet rough-
in fitting and install to be flush with the finished
wall. (plumbing must be done from backside of
finshed space)
ii. For new framing: Mount and install rough-in
fitting to be flush with finished wall +/- 1/8".
Connect a 1/2" NPT brass pipe or copper tubing to
the steam outlet union (not included) on the generator
running the pipe to the steam head location in the wall
to connect with the steamhead rough-in fitting. It is very
important that the pipe is firmly secured to the wall, so
that when the steamhead is installed it doesn’t push the
rough-in fitting back into the wall. Install a 1/2” drop-
ear elbow on the end of the 1/2” pipe or tubing for the
rough-in fitting. For all the connections, use solder for
copper joints and Teflon tape for pipe fittings and do not
over tighten fittings. DO NOT USE PVC CEMENT.
For detailed installation instructions of the
steamhead please see Installation section
in thermasol.com/customer-support
C
Turn ON the water supply to the generator. Check all the connections for leaks.
Plug in generator (unless hardwired model).
Turn ON the power source or breaker.
Verify control panel lights up and test operation. Note: Initial power-on phase takes several minutes for generator to
heat up steam.
Please direct the home owner to visit www.thermasol.com/solution and click on the “I’m the home owner” button to
learn about set-up and programing (in order to set up the clock and any other options if applicable).
Registration information on page 9.
Steamhead rough-in fitting to be
installed flush with finished wall
C
D
D
Steamhead + controls sold separately
AF Series Generator Installation Instructions
8 Final Pre-Check Before Operation