Installation Guide

Steamhead rough-in fi tting to be
installed fl ush with fi nished wall
A
B
Parts provided
by installer
Aromatherapy
Fill Channels
Place silicone
around groove
THERMASOL.COM
I
800.776.0711
Read warnings on page 3. For illustrative purposes only. Consult with qualifi ed professional for steam room construction details.
PN: 97005_NC 4/16
Steamhead Installation Instructions
Steamhead Location
Upon fi nal installation mount steamhead
with facing up to allow aromatherapy
well to dispense steam.
DO NOT install the steamhead near the seating area or
the user.
DO NOT forget to install the steamhead rough-in fi tting!
INSTALL steamhead as far as possible from the in-
shower controller. NEVER install the steamhead under
controller
Install the steamhead 12" from the fl oor or bathtub
rim and 6" from any corner.
Steamhead is to be mounted as far as possible
from typical bathing position (seated or standing)
and installed as far from the in-shower controller as
possible.
i. For retrofi t to existing fi nish wall:
Drill a 2-1/2" diameter hole in the shower wall or
wall above bathtub rim for the steam outlet rough-
in fi tting and install to be fl ush with the fi nished
wall. (plumbing must be done from backside of
fi nshed space)
ii. For new framing: Mount and install rough-in
fi tting to be fl ush with fi nished wall.
Connect a 1/2" NPT brass pipe or copper tubing to
the steam outlet union (not included) on the generator
running the pipe to the steam head location in the wall
to connect with the steamhead rough-in. For PRO-650
and PRO-850 run 3/4" copper steam line. It is very
important that the pipe is fi rmly secured to the wall, so
that when the steamhead is installed it doesn’t push the
rough-in fi tting back into the wall. Install a 1/2” drop-
ear elbow on the end of the 1/2” pipe or tubing for the
rough-in fi tting. For all the connections, use solder for
copper joints and Tefl on tape for pipe fi ttings and do not
over tighten fi ttings. DO NOT USE PVC CEMENT.
For detail installation instructions of the
steamhead please see Installation section
in thermasol.com/customersupport
A
B
3 Steamhead Location
O-Rings
Materials needed:
❏ Steamhead
❏ Steamhead Rough-In
Housing 1/2" Copper Tubing
(For PRO-650, PRO-850 -
3/4" drop elbow, 3/4"
Copper Tubing 50' max.
(2) 3/4" to 1/2" adapters)
❏ Silicone
❏ Other materials as required
Tools needed:
❏ 1" deep socket and ratchet
❏ 2 1/2" Masonry/tile/stone
Hole Saw
Steamhead
(Contemporary style shown here)
Installation instructionsSilicone
2 Tools and Materials
Parts enclosed
10