Installation Sheet

Read warnings on page 2. For illustrative purposes only. Consult with qualied professional for steam room construction details.
THERMASOL.COM
I
800.776.0711
6
7 Control Cable
NOTE: It is recommended to run the cable through electrical conduit.
Route the data cable (included with generator) through the nished wall to the back side of the control.
The other end of the cable runs to the steam generator location or if present the PDM.
Connect the data cable to steam generator connector.
Connect the data cable to steam generator connector.
(The other end of the cable runs to the back of the control in
the the shower location or to the PDM if present.
DO NOT pinch, nail, staple, wedge, or bind the
data cable.
DO NOT wrap the data cable around steam line or
route it in a manner so that the hot steam line could
melt the cable.
Any damage to the control cable will result in the
control not working properly.
Carefully connect the data cable to the generator and
control BEFORE turning power on to the generator.
"ON"
Turn Clockwise
"OFF" Turn
Counter Clockwise
• Do not staple, strain or damage data cable
• Align pins to receptacle visually before tightening
• Do not force plug
• Hand tighten only
Connector
Detail
Back of
control
or side of
generator
Side of generator
Contact pins
Contact pins Cable ends
Back of
control
or side of
generator
Back of ControlCable from
Generator
PRO Series Generator Installation Instructions