Installation Sheet

THERMASOL.COM

800.776.0711

Power Pak Series 3 Generator Installation Instructions

1. Once a location is determined, drill a 1 1/2"

diameter hole in the shower wall.

2. Connect 1" copper pipe or copper tubing onto the

steam outlet of the generator with a 1" union. Run a

1" copper pipe from the union to the 1 1/2" hole into

the wall. with 1/2 -1" of pipe protruding from wall.

3. Attach the steam head and escutcheon to the

copper pipe. CAUTION: Do not obstruct the steam

line with any shut-off valves, plugs, or caps.

NOTE: Make sure the steam head ARROW is

pointing UP as shown in the detail below.

4. Press the chrome cover over the steamhead with

lettering “HOT” upright and readable.

5. The steam line (pipe) can run up, down, or

horizontal it cannot run down and then up. If it

does, a steam trap will be produced at the low

point, blocking the ow of steam. Insulate the steam

outlet piping if the piping run exceeds 10 ft. or is

exposed to cold areas. NOTE: Use steam rated

insulation (225 °F minimum).

CAUTION

Avoid contact with the steam head! It will burn you! Avoid direct contact with the steam coming

out of the steam head! It is extremely hot! It will burn you!

ESCUTCHEON

WALL

COVER

STEAMHEAD

1" COPPER PIPE

Read the warnings on page 2. For illustrative purposes only. Consult with a qualied professional for steam room construction details.