Installation Sheet

15
THERMASOL.COM
I
800.776.0711
ThermaSol Power Pak Series 3 Control Operating Instructions
4. TEMPERATURE
Pressing the SET button will let you see the current steam room
temperature and enable you to congure the temperature set
point. Upon a rst press of UP or DOWN, the function LED will start
blinking and the set point will be displayed. Using the arrows, set the
temperature you want to be stored as the set point. The generator will
use this temperature as a threshold for maintaining and keeping the
steam room at the constant desired temperature. This temperature is
applied to all 7 days of the week.
5. STANDBY TEMPERATURE
Pressing the SET button will let you see the standby steam room
temperature and enable you to congure it. Upon a rst press of
UP or DOWN, the function LED will start blinking and the standby
temperature will be displayed. Using the arrows, set the temperature
you want to be stored as the STANDBY TEMPERATURE. In auto
mode, the generator will use this temperature for keeping the steam
room at the constant desired temperature when the steam room is not
occupied or the mechanical timer is off. This temperature is applied to
all 7 days of the week. If the unit is in override mode, this
setting is ignored.
6. SYSTEM POWER FLUSH
Pressing the SET button once again will enable you to set the
SYSTEM POWER FLUSH availability time. You should see the light
next to the power ush time come on and the display will show the
power ush time for the conguration day. Using the arrows, set
the time you want the ush to be available for that day from now
onward, press the DAY button for each day, and using the arrows to
set the time you want the unit to begin its power ush cycle. Once
again, the use of ALL for the day will apply the setting to all 7 days,
while pressing the DAY button will allow you to modify the time for
any specic day. The power ush stops automatically at the end of
its cycle (approximately 45 minutes). The power ush start time can
occur before start time (00:00 midnight with a 07:00 start) or after
hours (20:00 stop time and a 23:00 power ush start).
7. Pressing the SET button once again will display the days remaining
until the next actual power ush cycle is to commence. It will also
display the day of the week this event is scheduled to occur. This
gure is a function on the set interval requested and the actual usage
of the steam room. In order to change the desired interval while in this
mode press and hold the SET button for 5 seconds. The SET LED will
start blinking. Press the UP or DOWN buttons to adjust the required
interval. This interval is a function of water hardness and condition. It
will be adjusted for optimum conditions by a qualied user or by
the ThermaSol customer service representative.
Read the warnings on page 2. For illustrative purposes only. Consult with a qualied professional for steam room construction details.