Installation Sheet

THERMASOL.COM

800.776.0711

ThermaSol Power Pak Series 3 Control Operating Instructions

NOTE

Before proceeding, make sure all water supply, steam, and pressure valve connections are

complete and the water is turned on. Inspect for leaks and allow the tank to completely ll.

Make sure no electrical shorts or exposed wires are present, the generator is connected to

power, and the breaker is on.

1. CLOCK SET

Ensure the electrical/plumbing installation is complete. Turn on the

power to the unit at the breaker/disconnect box. The display will reset

to 00:00 and then display the current time of day. If the time and/or

day of week are not correct, press the DAY or UP/DOWN button to get

to the set clock menu. The CLOCK SET LED will start blinking. Press

the day to adjust the correct day of the week. Press UP or DOWN to

adjust the time. After 5 seconds, the system will accept this as the

valid time. You can also press the SET button to accept. The time

displayed is a 24-hour clock while the day of the week is marked by an

LED next to the DAY label.

2. START TIME

Now you will set the steam START TIME. Press the SET button once.

You should see the light next to the START TIME come on and a red

light next to ALL. The ALL feature sets the start time for all 7 days. This

saves time on entering redundant information 7 times. Using the DAY

button, you can customize the availability of steam and individually

change the start time on specic days. Press UP or DOWN once to

enter the START TIME change menu. The LED will start blinking. The

system comes from the factory with default values of 7:00 start time for

all seven days. Using the arrows, set the time you want the steam to

be available on that day.

3. STOP TIME

Next, set the steam STOP TIME using a similar method as the START

TIME. Press the SET button once. You should see a light next to

the STOP TIME. Press UP or DOWN once to enter the STOP TIME

change menu. The LED will start blinking. Using the arrows, set the

time you want the steam to stop for that day. Note that you are either

programming a specic day or ALL (1 full week). If ALL was the day

congured, the settings will be applied to all 7 days. If there is a need

to modify specic days, press DAY to move to the desired day to

modify the time settings.

Read the warnings on page 2. For illustrative purposes only. Consult with a qualied professional for steam room construction details.