Installation Guide

Doc. No: 81128 Page 12 of 16 Rev G 1/17
JWJ
5. Pressing the SET button once again will enable you to set the
Power Clean System (Figure 4) start time. You should see the
light next to the “Power Clean Time” come on and the display will
show the Power Clean time for the configuration day. Using the
arrows, set the time you want the flush to start for that day from
now press the DAY button for each day and using the arrows to
set the time you want the unit to begin its Power Clean cycle.
Once again the use of ALL for the day will apply the setting to all
7 days while pressing the DAY button will allow you to modify the
time for any specific day. The Power Clean stops automatically at
the end of its cycle. (Approximately 45 minutes). Power clean
start time can occur before start time (00:00 midnight, with 07:00
start) or after hours (20:00 stop time, and 23:00 power clean start).
Headquarters & Technical Support
1958 Steam Way, Round Rock, TX 78665 – [phone]
Mon – Fri 7:00 – 7:00 CST
FOR ALL OTHER CUSTOMER SUPPORT PLEASE CONTACT YOUR DEALER
Figure 4: Tank maintenance - power cleaning the tank.
CAUTION:
Be sure there is noone in
the shower area during
this cycle!