Installation Sheet

81098 Page 19 of 21 REV L 10/18 NJL

Day Spa Sentinel Installation Instructions continued,

6. THE FOLLOWING STEPS MUST BE TAKEN OR YOUR WARRANTY WILL BE VOID.

Coat the entire sentinel back with supplied waterproof silicon. Completely seal the sentinel

to the wall to create a moisture barrier. Place the sentinel on the wall pressing firmly. You

may need to tape the sentinel into place until the silicone dries. Be careful not to harm the

wall and / or sentinel with the tape

(Figure 13). Let dry for 24 hours before using.

Day Spa Sentinel Operating Instructions

Notes:

 The Day Spa Sentinel is an optional monitoring device. It does not control or change the status of room availability or

steam. The Day Spa functionality will not change with a system setup that includes the Sentinel feature.

 A special power save feature will make all four lights be dim green, when all four rooms are available. This is useful when

the Day Spa system is in standby operation or operates at after hour’s mode.

 In the case of a Day Spa that includes fewer than four rooms, e.g. 2 room setup, the unconnected rooms will be indicated

as green lights (available rooms) even though the Day Spa does not actually have them connected.

1. Functionality: The Day Spa Sentinel purpose is to monitor the activity use of the steam

room connected to the Steam Distribution System. A single Day Spa Sentinel is capable

of showing whether any of the four rooms connected to the Steam Distribution System is

occupied or not.

2. Room Availability: Available room will be indicated by a green light corresponding to

the appropriate steam room number. Occupied (in use) steam room will be indicated by

a red light. (figure 14)

1-1/16” hole in wall

for control wire

50 ft. control wire

(

to DS-SDS unit

)

Cover entire back surface

with waterproof silicone

ure13