Installation Sheet
81098 Page 16 of 21 REV L 10/18 NJL
Day Spa Control Operating Instructions continued,
WARNING: Please consult your physician before using this steam bath if you are pregnant,
elderly, have high blood pressure, diabetes, suffering from heart disease,
intoxicated, or in poor health.
1. Starting Your Steam Bath. Press the “Control Button” momentarily to activate your steam bath
session. Your control will come from the factor with a default setting of 60 minutes at 100F (to
change these settings move to steps 2 and 3) once the button is pressed you will see a green
LED appear indicating the time to be set, four seconds will pass and a red LED will appear
indicating the temperature to be set. (Figure 7)
Note: Green LED’s indicate the time and the red LED’s indicate the temperature.
2. Changing Session Time. While the green LED is still flashing (within 4 seconds), momentarily
press the “Control Button”. Repeat until the green LED associated with your desired time starts
flashing. Once the desired time is flashing, wait 4 seconds and that time will be accepted by the
control. (Figure 8)
3. Changing Session Temperature. After the time has been selected, the red 100 LED will
automatically start flashing. If this is the desired temperature, wait 4 seconds and that temperature
will be accepted by the control and the generator will start. If a different temperature is desired,
momentarily press the “Control Button”. Repeat until the red LED associated with your desired
temperature starts flashing. Once the desired temperature is flashing, wait 4 seconds and that
temperature will be accepted by the control and the steam will start. (Figure 9)
Figure 9
Figure 7
Control Button
Figure 8
Depress and repeat until
desired time starts flashing.
Depress and repeat until desired
temperature starts flashing.