Instructions / Assembly

46
• ApplicableModel
InstalltheremotecontrolleraccordingtotheinstructionsintheInstallationGuide.(p.43).
*Onlyonetheremotecontrollercanbeconnectedtothewaterheater.
 Amalfunctionmayoccuriftwoormoreremotecontrollersareconnected.
Optional Remote Controller
Remotecontroller
RC-9018M
* Thewaterheaterhasbeenfactorysettoallowamaximumtemperaturesettingof[120°F/50°C].
 Toaccesshighertemperaturesettingsthroughtheremotecontroller,followthebelowsteps.
<Whensettingthemaximumtemperatureto[125-140°F/55-60°C]>
1.TurnthewaterheateroffbypressingthePowerOn/OffButtonontheremotecontroller.
2.PresstheMENUButtoninsidetheremotecover,select"Miscsettings"usingthe
/ Buttons.
3.PresstheENTERButton,the"Miscsettings"screenappearsonthedisplay.
4.Select"MaxsetTemp"usingthe / Buttons.
5.PresstheENTERButton,[120°F/50°C]appearsonthedisplay.
6.Settheupperlimitofthehot-watersupplytemperatureto[125°F,130°F,135°For140°F/55°Cor60°C]
usingthe / Buttons.
7.PresstheENTERButton,"Setcomplete"appearsonthedisplayandthenreturnstothe"Miscsettings"
screen.
8.Toputthewaterheaterbackintooperation,pressthePowerOn/OffButtonontheremotecontroller.
Tokeepthewaterheateroff,eitherpresstheMENUButtonorlettheunitsitfor20sec.toreturnto
theoriginaldisplay.
• Whenchangingthetemperature,makesuretoconrmwiththecustomerthatthetemperatureof
thehotwaterwillbeveryhighandthatthereisariskofscalding.
• Hotwaterheatertemperaturesover125°F(52°C)cancausesevereburnsinstantlyordeath
fromscalding.
DANGER
*Remarks[125°F/55°C]
Fahrenheitdisplaymode
Celsiusdisplaymode