Instructions / Assembly

45
2.Removethedecorativeframefromtheremote
controller. (The remote controller is inserted
inthedecorativeframe.)
3. Connect theremotecontrollerwirestothe
cordsuppliedwiththewaterheater.
*IftheY-shapedterminalisnot covered, the
exposed section may come into contact with
the mountingbracketresultingin improper
operationorfailure.
4. Securetheremotecontrollerwiresbywinding
themaroundthenotchesasshowninFig.1.
5.Attachtheremotecontrollertothemounting
 bracket.Insertthebottomoftheremote
controllerintothegrooveatthebottomofthe
bracketandpushinthe2hooksontopofthe
remotecontrollercompletely.
*If it is difcult to attach, do not try to force it
asitmay result inbroken hooks. Checkfor
properalignment inthegrooveorforloose
wiresobstructingtheremotecontroller.
*Donotinstallonthe
bracketbyforce,the
hooksmaybreak.
Hooks
Groove
Mounting
bracket
Main remote
controllerbody
6. Securetheremoteusingthemachinescrews.
7. Attachthedecorativeframewhichwas
removedinthesecondstep.
 Pushthe 4 corners of the decorative frame
untilthereisaclick.
*Incomplete
installationmay
resultinfailures
suchasswitch
operationfailure.
Note:Toremovethedecorativeframeafter
installationof theremote controllerand
theframe,pulltheentiredecorative
frameforwardwhilepressingthesections
indicated(wherethefingersare)inthe
gurebelow.
*Ifitdoesnotcomeoff,insertaathead
driverintothenotchatthebottomofthe
decorativeframeandslightlytwistitto
remove(duecautionisrequirednotto
scratchtheremotecontroller,decorative
frameorthewallindoingso).
Click Click
ClickClick
Putngersintothisgap.
Main remote
controllerbody
Machinescrew
(accessorypart)
Rearsideoftheremotecontroller
Fig.1
Windingaroundthenotches
Passtheremote
controllerwires
throughthenotch.
SectionA
Insulatingcover
(Donotremove
thecover.)
Mountingbracket
Remotecontrollerwires
Forwiringinsidethewall
Forexposedwiring
Remotecontrollerwires
*Checkthe terminalis
coveredwithSectionA
() oftheinsulating
cover (clear,seeFig.1).
THIS SIDE UP
Remotecontrollercord
Forexposedwiring,usescissors
orshearstocarefullycut “the
wiresinlettab”ofthedecorative
frametocreateslotforwires
beforeattachingtowallmount.
Wiresinlettab
Decorativeframe
Removetheremote
controllerwhilepulling
thedecorativeframe
forward.
Decorativeframe
Main remote
controllerbody
*Donotremovetheremotecontrollerwires
fromtheterminalblock,connectthesewiresto
theremotecontrollercord.
*Donotremovetheinsulatingcover(clear).
*Somemodicationsarerequiredontheframe
tocompletetheinstallation.Seenotebelow.