TMT-9000S User Manual

4
www.thermaltronics.com support email: [e-mail]
UNPACKING/ASSEMBLY/OPERATION
Please read this manual and follow the directions before using the equipment.
The carton contains:
1. Instruction manual
2. TMT-9000PS power supply
3. SHH-1 Soldering handpiece holder, including Brass curls and sponge
4. SHP-1 Soldering handpiece, with green and grey grips
5. RMP-1 Tip removal pad
6. M7CH176 Soldering Cartridge
Important: Keep all shipping materials until satisfactory operation has been veried.
Assembly and Operation
1. Remove TMT-9000PS power supply base from its box and place on a suitable work
bench equipped with AC power.
2. Remove the SHH-1 work stand from its box. The unit should include a brass tip
cleaning curl and a rectangular sulphide free sponge.
3. Remove the SHP-1 handpiece from its box and place into iron holder.
4. Plug the handpiece cord into one of the front connectors and ensure that the slide
switch is positioned towards the plugged handpiece.
5. Plug tip cartridge into handpiece
6. Moisten the sponge with DE-Ionized water.
7. Connect the AC plug to a suitable AC power outlet.
8. Switch the power switch to the “on” position
9. Allow a few seconds for tip cartridge to reach soldering temperature.
10. The unit should then be ready to use.
Temperature Calibration
Thermaltronics “Curie Heat Technology” systems do not require temperature
calibration. The technology is very precise and is self regulating. The alloy used in the
construction of the tip cartridge will maintain the set temperature for its entire life.