User manual

3.2 Case LED connections

On the front of the case, you can find some LEDs and switch leads

(POWER SW*1, POWER LED*1, H.D.D. LED*1, RESET SW*1).

Please consult user manual of your motherboard manufacturer, then

connect these leads to the panel header on the motherboard. These

leads are usually labeled; if not, please trace them back to the case

front to find out their source.

- POWER LED connects to your M/B at the PLED.

- POWER SW connects to the PWR connector on the motherboard.

- H.D.D LED connects to the 2-pin labeled HDD LED connector.

- RESET SW connects to the RSW connector on the motherboard.

3.3 USB2.0 & IEEE1394 Firewire connection

Please consult your motherboard manual to find

out the section of "USB connection".

USB connection

USB2.0

GND1

Data+1

Data-1

GND2

Data+2

Data-2

Vcc 2

Brank)

Vcc1