Manual

O
ARGB Controller Installation Guide
1. Light Mode:
Switch over between 7 LED modes.
3. Light Speed:
Switch over between 4 light modes.
When light mode is in RGB Spectr um:
Click to memorize and lock the color you want, click again to unlock the 256
colors auto rotation.
Red → Yellow → Green → Teal → Blue → White → Purple
When light mode is in Ripple :
Switch over 7 LED colors .
When light mode is in Wave and Flow :
LED color can not be adjusted.
Red → Yellow → Green → Teal → Blue → White → Purple → Rainbow
2. Color Mode:
When light mode is in Full Lighted, Pulse and Blink :
Switch over 8 LED colors .
Rainbow → Full light → RGB Spectrum → Off → Flow → Radar → Pulse → Blink
Slow → Normal → Fast → Extreme
M
M
M
N
N
N
MB SYNC Installation Guide
1. To use Motherboard RGB Software, please only
connect Cable F to the water block
2. Please power off the PC and check the Positive
and Negative ends on the connector before
connecting the cable to the mainboard.
Connecting the wrong end can damage the product.
CAUTIONCAUTION
CAUTIONCAUTION
Installation Guide
1
1
1 2
K
2
2 3
3 4
SATA
B
J
A
FAN
CPU_FAN
B
© 2021 Thermaltake Technology Co., Ltd. All Rights Reserved.
www.thermaltake.com
Intel
or
AMD
PUMP
SYS_F AN
A
PUMP
A
A
A
A
A rotatable LED cap built-in
waterblock accommodates
re-orienting the logo no
matter the direction the
cooler is installed
MODE
COLOR
SPEED
To use the ARGB Controller, please only
connect Cable E to the water block
SYS_F ANSYS_F AN