User`s manual

Aqua RX series -R2Aqua RX series -R2
Aqua RX series -R2
All in one CPU Liquid Cooling
Apply a thin layer of thermal compound(J)
onto the processor.
Place waterblock on the processor
through the screws(D) as shown on photo.
Tighten the thumb
nuts(I) to the screws as
shown to fix the waterblock
on motherboard.
Attach H-type
clips(including ABC)on the back
side of motherboard.
Insert the screws(D) into the
two holes as shown in the photo.
Put the washer(G) along
the screws to
prevent the electric
current.
Combine the insulator (B)
and the cushion (C) using
the adhesive. Stick the metal H-type
clip(A) with the insulator and cushion (BC).
Tear off the protective layer to adhere
it onto the motherboard.
Put the stand offs(H) along
the screws(D) to fix the
screws on the
motherboard.
Note: Placing the cushion onto the
motherboard with the adhesive will
prevent you from removing the cushion
in the future. If you are planning to
remove the cushion for future use,
please don't remove the protective tape.