User`s manual

Aqua RX series -R2Aqua RX series -R2
Aqua RX series -R2
All in one CPU Liquid Cooling
Insert the screws (D) into the
four holes as shown in the photo.
Put the washers(F)
along the screws to
prevent the electric
current.
Attach H-type
clips(including ABC)on
the back side of
motherboard.
ushion
Combine the insulator(B)
and the cushion (C) using
the adhesive. Stick the metal H-type
clip(A) with the insulator and c (BC).
Tear off the protective layer to adhere
it onto the motherboard.
Tear off the tape on the
back of the insulator (B)
and place it on the metal
H-type clip(A).
Note: Placing the cushion onto the
motherboard with the adhesive will
prevent you from removing the cushion
in the future. If you are planning to
remove the cushion for future use,
please don't remove the protective
tape.
Secure both quick connectors onto
the waterblock.
Installation complete
4-1 Secure the Waterblock on CPU (Intel LGA775)
Intel LGA 775
Motherboard
A. Metal H-type clip
B. Insulator
C. Cushion
D. 50mm screws
F. Red washers
H. Stand offs
I. Thumb nuts
J. Thermal compound
Components for LGA 775:
4. Waterblock Installation
A
B
C
D
F
H
I
A
B
C
D
F
I
H
3. Connector Installation
There are two types of quick connectors (6.4mm [1/4"] ID and 9.5mm [3/8"] ID).
You can apply to the situation that fits your liquid cooling system .
The following diagrams are 9.5mm ID (3/8") quick connector.
NOTE:
Before installing, please make sure that the connectors are tightened properly.
J