Datasheet

-9-
BALCK GND, GROUND
USB Port Pin Name
3) External IR Receiver (iMON Station, iMON Knob) Installation
Connect your External iMON IR Receiver (iMON Station or iMON Knob) to your USB port. If you connect the
iMON IR Receiver before the S/W installation, then assign the H/W driver according to the ‘Found New H/W
Wizard’. Select CD ROM drive for searching H/W driver which has the installation CD inside.
4) Internal IR Receiver (iMON Inside, iMON VFD, iMON OEM) Installation
The additional feature of internal type iMON IR receiver is that you can power on your PC system using the
power button of the remote controller. Internal iMON IR Receiver can be loaded to the 3.5’ (iMON Inside) or
5.25’ (iMON VFD) disk drive bay. Some iMON OEM versions already loaded on the cases. After turn off your
PC system, open the PC case and connect the cables to its proper pin refer to the following picture. Internal
IR receiver is connected to mainboard with two cables, PC case with one cable, Power Supply with another
cable. You should be careful to connect these four cables refer to your mainboard manual. If you connect
the iMON IR Receiver before the S/W installation, then assign the H/W driver according to the ‘Found New
H/W Wizard’. Select CD ROM drive for searching H/W driver which has the installation CD inside.