Product Manual

Manual 0-5185
7
Enclosure Installation
10.Installation:Liftupthecontactorandplacethebottomenclosureunderneath.TheendwiththeOblongslotin
the bottom and the four detents goes toward the front of the Cutmaster. Slide the Contactor completely forward
andattachthepartstotheoriginalcontactormountingpoints.Tightenallelectricalconnectionsto17+/-1In/
lbs.LiftingtheCutmasterandshiningalightbelowthebasepanelwillilluminatethemountingholestoassist
withalignment.OrientcontactorwiressothattheyareabovethedetentsinthebottomenclosureLOAD(T1-4)
side,asshown.Thewire#7detentwillalsohavecontactorcontrolwires#1,#2,#5and#6laidunderneath,as
shown.Pushwires#1,#2,#5and#6betweencontactorandtheboxwall.InputACpowercordwireswillseparate
betweenthetwodetentsontheLINE(L1-4)sideoftheboxbottom.Ifa3phaseACpowercordisused,populate
L1andL2intothefurthestback(inner)detentandL3tothefront(outer)detent.
Figure18:ContactorBottomFigure19:ContactorWireRoutingLoadSide
Figure20:ContactorWireRoutingLineSide